Peugeot 308 Key Fob Replacement
Peugeot's 308 might seem somewhat old-fashioned but it's attractive. It's not the most luxurious car in its class, but it's an enjoyable and comfortable drive.
Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. The following tips will aid whether the issue is constant or intermittent.
Water Damage
When you accidentally leave your fob in the midst of a puddle or get it wet when kayaking, swimming, canoeing, rafting or canyoning, it's more likely to suffer water damage. Keep your key fob in a dry bag whenever you are outdoors or engage in activities that expose it to excessive amounts water.
It is also important to ensure that the fob is dry before opening it up and reusing it. If you detect any odors emanating from the fob (such as industrial fluid or windshield washer fluid) It's another indicator that it is submerged.
A circuit board that is wet could cause the battery's charge to drop its charge, or even explode. If you're able, if you can, pull your 308 key fob out of the water in which it got stuck in then flip the button side down and shake it out as much water as possible before opening the case. After you open it, take out the battery and clean the circuit board using a cotton swab dipped in 90 percent isopropyl alcohol.
Other reasons that your Peugeot 308 remote entry keyless system may not work include a dead battery in the coin-cell, receiver module problems signal interference or a malfunctioning chip. If none of the above are the reason, you may try resetting the system by removing the battery that is 12 volts for approximately 15 minutes.
Dead Coin Battery
Peugeot cars come with a remote start system that allows the driver to start the car from a distance while warming up or cooling down the car prior to entering. This feature is extremely beneficial, especially in the cold winter months. The remote start system can stop working for a variety reasons, including the battery being dead.
The coin-shaped battery that is inside the key fob could last between two and four years depending on how frequently it is used, where it was purchased, and the way it is used. The date of use will be printed on the packaging or marked in the user's manual.
If the key fob stopped functioning after exposure to clean tap water it is recommended to remove the battery, then clean the chip using a paper towel and isopropyl ethanol, then dry it thoroughly before replacing it. If the key fob has been exposed to salty or soapy water, it may have caused the chip to be damaged. It is necessary to replace it.
If you're unsure if the battery is in good condition You can test its voltage with an instrument set to the car's voltage range. Connect it to the minus and plus terminals. The voltage should be between 12 to 13 volts, but if it is lower, the battery needs to be replaced. If you want to, you can try to reset your on-board computer by disconnecting the battery at 12 volts for a few minutes and then reconnecting it in reverse order (positive cable first, then negative). The engine should now begin.
Faulty Receiver Module
If you're not getting the "Key Detected" message on your dashboard, then it's possible that the receiver module has created a fault. It's the part that transmits an indication to the car when the key fob is activated it also acts as an immobiliser. It also stops it from starting until the correct key is in place.
The cause could be various reasons, such as water damage or simply getting old. If your Peugeot 308 key fob was exposed to dirty tap water, like the chip that is located inside may be damaged. In G28CarKeys 'll need to remove off the battery and clean it thoroughly using isopropyl alcohol or an electronic cleaner. Once it's dry, you can put the battery back in and test it again.
If the problem persists it is recommended to visit the local Peugeot expert or locksmith. They can employ a diagnostic tool in order to pinpoint the issue and then fix it.
It can be a stressful experience to lose your Peugeot car key. A professional auto locksmith will be able to solve the problem within minutes. They can cut a new key and programme it to your vehicle, ensuring that you can get back on the road again in the shortest time possible. Click here to find a local locksmith near you.
Faulty electronic chip
The electronic chip inside the Peugeot 308 key fob plays a vital role in the remote control system. If the chip is damaged, you could have problems starting your car or receive a message saying "anti-theft". In this scenario, the only solution is to replace the key. Auto locksmiths with experience are able to provide the fastest possible time.
The chip in your Peugeot 308 key fob can be damaged due to water damage, sweat dirt, or other reasons. If your Peugeot key fob has been exposed to soapy or dirty water, it should be cleaned promptly. You can make use of a towel and isopropyl alcohol for cleaning the electronic component. After that, allow the battery to completely dry.
Radio interference can cause the key fob to stop working. This could be due to other devices operate on the same frequencies as your Peugeot keyfob. This could be due to unsafe conditions or objects that are in the vicinity of the vehicle. It is recommended that you visit a Peugeot dealer if you experience this problem.
The Peugeot key fob 207/308 is extremely delicate and requires a lot of attention. You shouldn't drop it or throw it around. If you lose something, try to locate it as soon as you can. You can reset all on-board computers by disconnecting the 12 volt battery for a few minutes. Make sure you disconnect the negative cable first, then the positive.